Kool It Down Air Conditioning

Introduction: Our services include the following: 1) Obtain and maintain required certifications. 2) Comply with all applicable standards, policies and procedures, including safety procedures and the maintenance of a clean work area. 3) Repair or replace defective equipment, components or wiring. 4) Test electrical circuits and components for continuity by using electrical test equipment. 5) Reassemble and test equipment following repairs. 6) Inspect and test system to verify system compliance with plans and specifications and to detect and locate malfunctions. 7) Discuss heating-cooling system malfunctions with users to isolate problems or to verify that malfunctions have been corrected. 8) Record and report all faults, deficiencies and other unusual occurrences, as well as the time and materials expended on work orders. 9) Test pipe or tubing joints and connections for leaks, using pressure gauge or soap-and-water solution. 10) Adjust system controls to setting recommended by manufacturer to balance system by using hand tools. 11) Recommend, develop, and perform preventive and general maintenance procedures such as cleaning, power-washing and vacuuming equipment, oiling parts and changing filters. 12) Lay out and connect electrical wiring between controls and equipment according to wiring diagram by using electrician's hand tools. 13) Install auxiliary components to heating-cooling equipment, such as expansion and discharge valves, air ducts, pipes, blowers, dampers, flues and stokers by following blueprints. 14) Assist with other work in coordination with repair and maintenance teams. 15) Install, connect and adjust thermostats, humidistats and timers by using hand tools. 16) Generate work orders that address deficiencies in need of correction. 17) Join pipes or tubing to equipment and to fuel, water or refrigerant source to form complete circuit. 18) Assemble, position and mount heating or cooling equipment by following blueprints. 19) Study blueprints, design specifications and manufacturers recommendations to ascertain the configuration of heating or cooling equipment components and to ensure the proper installation of components. 20) Cut and drill holes in floors, walls and roof to install equipment by using power saws and drills. 21) Wrap pipes in insulation, securing it in place with cement or wire bands. 22) Measure, cut, thread and bend pipe or tubing by using pipefitter's tools. 23) Fabricate, assemble and install ductwork and chassis parts by using portable metal-working tools and welding equipment.