WELDERS 1st CHOICE and TERRY will be my first choice for any welding work I or my friends may need. I had two custom gates made by Artistic Iron Works that took over 3 months to make and 3 visits to my home and after 3 different measurements a letter to the BBB. Visit by the Nevada State Board of Contractor’s Investigator Gary Copenhaver who said this work was acceptable, look at the pictures, what do you think I’m filing a complaint on them. I’m going to court now against Artistic Iron Works. I am now happy with my gates thanks to Terry and his company WELDERS 1st CHOICE. TERRY IS A HONEST MAN OF INTEGRITY AND TAKES PRIDE IN HIS WORK, AND CRAFTSMANSHIP. In 5 hours on site Terry refrabricated my gates in the blistering heat . Terry and his crew of two, cut down 6 inserts for holding glass cleaned up the welds and repainted. Cut new striker holes for deadbolts so I could remove the ugly plate that covered poorly drilled holes. Cut down post on west gate so height matched the wall and welded caps back on. East gate removed fence panel, and post. Removed all iron from house and wall. Repaired hole in stucco and block wall. Removed black silicone from wall cement. Repainted stucco and wall to match house and wall. Cut off 4 hole plates from wall section of fence. Installed appropriate 2 hole plates. Cleaned up welds and repainted and reinstalled level to wall. Cut off hinge side post from fence section, and moved it forward 5 inches. Cut plate and rewelded post level, and resecured plate in new location. Cut off one hole plate, 1” sleeve and 1 1/4 extension, between hinge post and fence. Installed more appropriate 1 1/2 material between hinge post and gate. Welded in screw hole and cleaned up affected area from old post location. Removed screws, silicone, and spacers from old post location. Removed screws and spacers from old location of posts and replaced with more appropriate 1 1/2 piece of material between hinge post and bottom of fence to match bottom rail of fence to strengthen post. Also, for a cleaner look , rehung gate. Cut down striker post , and welded to plate at proper height to match the decorative design of the gate, and concrete. Cut off tab at the bottom of striker post, as it was unnecessary, and added another plate to the top so the post was level. Moved post forward approximately 5” to match gate. Resecured plate flat to the ground. Resecured top tab with screw. Cut new striker hole for lock. Terry also repainted all areas he worked on including my brick stucco wall. He did not use any silicone to fill in bad craftsmanship. He used welds and good measurements and if corrections were needed he did the work over again. I wish I would have found WELDERS 1st CHOICE first would have same me time and frustration. You know when you find a good guy when other Welders know his work and recommend him. THANKS TERRY FOR FIXING MY HORRIBLE CUSTOM GATES.
TERRY AND HIS CREW MADE IT RIGHT.